Modem to network optical isolator6/4/2023 The DTE side and a DB25P male connector on the DCE side of the isolator. The isolator has a DB25S female connector on The Model 232SPOP4 optically isolates four RS-232 lines. Additional isolation on the power supply circuits adds a third degree of protection. Powerful isolation on both data ports protects your equipment and data from damaging ground loops and surges. These specifications are more stringent than the NEMA TS1/TS2 requirements for transportation applications. Meeting the requirements of IEC 61850-3 and IEEE 1613, it is suitable for installation in electrical substations. Designed for rugged industrial environments, it has been put through some of the most exacting compliance tests in the industry. The 232OPDRI-PH is our premium Heavy Industrial RS-232 Isolated Repeater. Powerful Optical Isolation on both data ports protects your equipment and data from damaging ground loops and surges. Designed for rugged industrial environments, it is UL listed and certified for use in Class 1 Division 2 locations. The 232OPDRI is our premium Industrial RS-232 Isolated Repeater. The 232OPDR can support two data pairs or one data pair plus control signals in both directions. It also functions as a repeater to extend RS-232 signals another 50 feet. The isolation provides protection for computer equipment from ground loops and induced currents caused by lightning or heavy electrical loads. Connections are made to a terminal block. The isolator has four LEDs to show data flow and one LED to indicate power. It provides 2000 V Isolation for four RS-232 signal lines, two in each direction. The 232OPDR is a DIN Rail mountable RS-232 optical isolator and repeater. We also offer versions with UL 508 and UL Class 1 Division 2. They have advanced EMC and emissions specifications that run the gamut from light industrial EN 6 to heavy industrial EN 6 with IEEE 1613. If you require extended temperature ranges and extra rugged construction, our industrial products will fit the bill. They provide 2 kV of isolation to protect your equipment as well as a variety of connector options. Our RS-232 optical isolators are ideally suited for many applications – from “control panel” installations requiring DIN Rail mounting to “in-line” or “bump in the cable” installations found in laboratory or retail systems.
0 Comments
Leave a Reply. |